Blog

Gens Ace Tattu

Today i am proud to announce that i will be supported by the Gens Ace Tattu brand. I would like to thank them for their support and for giving the RC community in general such good quality products.

I have been a huge fan of Gens Ace batteries since they first came about.  They were always the first choice to go in my 3d model helicopters.

I look forward to giving my FPV setups the edge on the track by flying their Tattu FPV race packs.

1 Comment

  1. 04/10/2015

    Another practice day at our club race track at Chuter Ede. Have come across an issue with my basher Vortex. It does not seem to corner well at all. If you give a little too much yaw command then the whole back end looses it and spins out. It does not feel as locked in as the racing vortex even though the setup is identical. Tried few different props now and all with the same results. Going to check the motor alignment, i have 3d printed a tool in preparation for this. Other than that its a strip down to see if i have damaged anything.
    Not the best flying day for me however still had fun with the rest of the FPVR Pirates… ooooahhh arggggghhhhhh!

Comments are closed.